Removing antenna motor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2005
Threads
59
Messages
1,733
Location
Small Waves, FL
First off: I've searched.

I need to remove the antenna motor (97 LX450) to remove the broken plastic mast gear.

Problem is the 10mm bolt that secures the motor bracket just spins (flashback of rack removal). I can feel a nut on the backside of the bolt.

How do I get this thing loose? Thanks.
 
I've had my antenna motor out a couple of times. Other than being cramped, I don't remember any problem. Can you get a wrench on that nut?

-B-
 
Three hands are better than two. It's hard. Try to be patient and you'll get it. Keep your magnetic extension wand on hand.
 
Last edited:
Beowulf said:
I've had my antenna motor out a couple of times. Other than being cramped, I don't remember any problem. Can you get a wrench on that nut?

-B-

Well, I can barely get two fingers on it so I'm guessing it's physically possible. I anticipate reinstallation to be a royal b i t c h.

I'd like to hear from people who have done this.
 
I do remember gear wrenches help a lot and the magnetic pick up tool is a must
 
Great info we still have yet to replace ours.

thanks Romer
 
Don't psych yourself out. I've done it - you can do it. Post pics and ask questions if you need to.
 
ok so reviving an old thread, im in the process of removing the motor assembly. got the mounting bolt out, and as i was trying to remove it, i noticed there are two wired connections. one set is the power wiring leading to it from the engine bay, the other looks to feed from the bottom of the mast to just under the windshield area through a grommet. im guessing this goes to the back of the receiver.

...so how did everyone pull theirs out? doesnt seem to be a way to disconnect it. and of course, its not long enough to allow me to pull the motor out... :bang:
 
I just replaced my antenna today, it was a snap I had the fender off. The reason the fender was off was to realign it and fix some rust from the PO's body shop mess up not for the antenna but it made it real easy. I have a question about the OEM antenna when its fully extended is it straight up and down or does it bend slightly toward the windshield like mine? I have no idea if this is normal because when I bought the truck the PO had replaced it with a cheapo aftermarket POS.

Thanks
George

PS- Don't remove your fender, be patient take a break and try later. Be sure you pull the antenna lead grommet out of the body follow the lead in the fender you will feel it.
 
got it sorted. saw on another thread this link:

Lexus LX450/ Land Cruiser Tech Index Page

the coax cable that goes to the cabin is just long enough to get the bottom of the assembly motor to peer out of the hole. you'll have to remove the mounting bracket while the assembly is still in the fender. i removed one bolt, swung it around to get more of the motor out, then removed the other. the motor assembly could now be pulled out of the service hole far enough to undo the cover and get to the broken mast. did the same with the install.

gear wrenches definitely do help...glad i scored a set of flex heads last month. cant wait to try it out on the PHH...
 
Back
Top Bottom