Red brake light on when cold

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 5, 2006
Threads
167
Messages
1,481
Location
Albany, NY
My emergency red brake light stays on when the car is very cold. I don't mean the engine is cold but ambient temperature. Normally when I disengage the e-brake the light goes off. The light will either stay on, or will be on when I start the car even if I did not apply the e-brake. Once the cabin warms up, the problem goes way.
Can someone shed light on where the switch is and why it is affected by temperature?
I can only guess that the cold shrink some plastic the pushes on the switch.
 
Also check the fluid level for the brake system. This started happening to me after the vehicle sat for a while, especially after being parked on a grade. Pads were worn so the fluid level was just touching the low level warning, which also triggered the lamp.
 
OK, the brake fluid was below min line.
I added DOT 3 brake fluid to be mid point between min and max.
Now I have to wait to next winter to see if this helped. :-)
We did have a cold day yesterday and the light did not go on. But I have to wait for a 10 degrees day to realy see it.
Anyway, this form is great. and thanks for the tip.

PS. another tip I followed was to relpace the PHH. I bough Bret kit and apperantly I did it just in time because the orig PHH was already starting to leak per my mechanic.
 
One other thing to be aware of, as the pads wear out, the fluid level goes down. Unless you have a leak somewhere now would be a good time to check the pads, they may be near the end. Better to check now than end up buying new rotors.
 
My emergency red brake light stays on when the car is very cold. I don't mean the engine is cold but ambient temperature. Normally when I disengage the e-brake the light goes off. The light will either stay on, or will be on when I start the car even if I did not apply the e-brake. Once the cabin warms up, the problem goes way.
Can someone shed light on where the switch is and why it is affected by temperature?
I can only guess that the cold shrink some plastic the pushes on the switch.

LOL That´s a clear message from your cruiser to stay at home under a nice and warm conforter til spring:grinpimp:
 
My pads were checked when I bought it Feb 06 and were replaced as part of purchasing the vehicle. thanks for everyone's input.
 
Mine just started going on. I just unplugged the wires going to the reservoir lid, problem fixed. If you’re a DIY kind of guy you don't need the light to tell you when your low since you will be under the hood all the time anyway. I think you can get one from CDAN for $20-$30 if you really feel a need for one.
 
Back
Top Bottom