Rearching springs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 11, 2005
Threads
29
Messages
212
Location
Maple Ridge, BC
Sooo, I'm thinking of getting my stock springs rearched. Before I send them in I wanna take them apart and wire wheel the rust off and paint them. So it is ok to cut off the alinement clamps on the springs. A couple of them were already bent back by the P.O. Should i replace them with band clamps after, or just let the springs be??
 
Hmmm that was a good read, and its got me thinking. I would like to get OME springs, but the rearching looked cheaper. Hmmm I guess its OME springs then.
 
I had my springs rearched on my 60 about 4 years ago and still love it. They added a leaf along with the rearch. It is a very smooth ride...the only difference before and after is that I no longer bottom out on the axle:) And it is about 1/3rd the cost of a lift kit. Find a reliable outfit to do it...the place I took mine to had 2 fire engines, several rigs from Michigan, New york, and a few other states. This guy had been in the spring business for about 20 years and new his stuff. Good luck.
 
Why?

You want them back to stock, or higher?

If you want stock, I think it's a good idea. I had mine done. It was $140 for a pair. I'm going to have him do the driver's side up a bit more so I can eliminate the leveling block.

IIRC, the rearch involved some beating with a hammer, so you should clean and paint afterwards. Mine were done as part of the deal, though not as well as I would have done myself.

If you're doing as an alternative to a lift, I'd get OME springs instead.
 
I also had mine done and very happy with it. I achieved a mild lift - probably about 1 or 2 inches above stock, but comfortably fits 33x12.5x15 MTR's (with rear guard trim). I also had an extra full length leaf added, then pulled two short leaves from the rear & one from the front. With longer rear shackles & longer travel shocks, it gives pretty reasonably articulation, & the ride isn't too harsh (for what it is..) Had it done a year ago & hasn't sagged yet, but plan to replace short leaves if it does. From what I've seen, it's at least as good as new 2in lift springs, & better than some brands, and heaps cheaper..
 
The Belton kits that are readily available here in B.C. are very good springs .They are about a 2-1/2 " lift over stock .cheaper than the OME 's but In my opinion they are a good spring .
 
Well I'm going spring over in my rebuild, and I've heard that the old stock springs are super flexy, so if I keep them I wanna have them rearched back to stock. My other choice is OME springs which I really like too.
 
Back
Top Bottom