rear windows

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2016
Threads
12
Messages
31
Location
federal way washington
I have a 1994 land cruiser and both rear windows comes out of the metal that pinches window. The metal u shape channel were window is glue into. Any way of regluing the window into channel. And the windows dont roll all the way up. They both stop about 1in from totally being rolled up all the way.
Any info will be great.
Thank you
Kenny
 
I'm not following you - the windows are not glued in. There is a flat-like window seal/run that the glass slides up and down on that sits next to the glass, maybe this is bad on yours? Can you post some pics on what you're referring to?
 
X2^
 
I cleaned the rubber, window and channel really well and then re-inserted the rubber into the metal channel with a piece of thin card-stock between the rubber and the metal to act as a shim/spacer to increase the tension. I then used a soapy solution in the rubber and on the window and lightly hammered the window into the rubber from the end (using a dead-blow, rubber mallet) until it lined up properly. Has worked for me for 2 years now with no issue
 
Ok ill try the tapping with hammer. I think the adhesive tape the hold the window in is all out of stickiness. Do you know what could be used to make window stay in metal piece. And the issue of not rolling up all the way?
Thank you for you reply
Kenny
 
again, the window is NOT held in with adhesive. what other posters are referring to is the bottom window trim. perhaps a PO put adhesive on that to secure it to the door? but that does not "hold" the window in. And the window trim is not glued on, it's held on with white plastic one time use clips. Using adhesive to secure these is klugey.
 
as far as why your window won't roll up, it could be a couple of things

1- your inside C-channel rubber is bad causing it to bind
2- you need to grease your regulator with some white lithium grease
3- your window motor is bad/weak

You will almost assuredly need to remove your door panel to look inside.
 
Ok. Ill look in door panel again. The mower being weak or bad motor? All windows roll up same speed. Slooooowww. Like a turtle on loods. I read the you have to reset the motor to make it roll all the way up. Has anyone heard of this theory?
Kenny
 
Kenny, I've never heard of resetting a window lift motor. There's a thread on Mud showing how to disassemble, clean and reassemble the motor, and how to grease the motor drive gear and regulator. I had to replace all four window runs, the motor and regulator on the driver's door, plus the master switch panel on the driver's door. All go up and down easily now.
 
I'm having a similar problem on my drivers door window. I haven't opened it up yet and I'd like to get what I need to fix it beforehand. Is the window held in the channel by any type of adhesive or just "pinched" at the bottom?
 
Pinched
 
No prob
 
Back
Top Bottom