Rear Vent Window Hinge Screws

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 17, 2011
Threads
33
Messages
222
Location
SE Michigan
Piecing back together my 1978 hard top. Can someone tell me the size screw that goes to the (3) buttons in the vent window glass? Thanks to Rudi for the pic.

upload_2016-1-12_9-13-26.webp
 
don't know the size but you can get them new from Toyota
 
PN Microfiche shows them as the same PN as the hinge to hard top screws...

Although in your picture, they look smaller, I'd be interested to know if they are not interchangeable with the 4 hinge screws?
 
the factory ones have a large black head(maybe 3/8") on them, I can't think of anyplace else they are used
 
Thanks for that p/n. They look small - like maybe the elusive 5mm x 0.9 thread. The hinge to hard top screws look like maybe 6mm. I'll run out to the garage and dig some screws up to try (I have plenty of 6mm and might even have some 5mm), but it's 15 degrees (F) with a good wind and a few inches of snow waiting in the drive between me and the garage for me to shovel :crybaby: I'd better get that snow shoveled before :princess: gets home and tells me for the 1000th time that she could get her car in the garage if it weren't for the 40 and all the parts taking up all the freakin space! :rolleyes:
Maybe I can get some from Beno pretty quick, then it will be done right.
 
Hey Guys, with regard to this window and the screws, are they to be tightened as an adjustment? I have a brand new build, glass, hinges and weatherstrip but I still get water in from the top when it rains. I notice that the screws were loose which tightened up the seal quite a bit but still get some water in. Looking to find out if it is an adjustment that I am just not doing correctly. 1981 FJ40
 
Hey Guys, with regard to this window and the screws, are they to be tightened as an adjustment? I have a brand new build, glass, hinges and weatherstrip but I still get water in from the top when it rains. I notice that the screws were loose which tightened up the seal quite a bit but still get some water in. Looking to find out if it is an adjustment that I am just not doing correctly. 1981 FJ40
Joe,

I had to make some adjustment to mine also. They would not open or close well because the hinges were hanging up on the weather stripping. I ended up taking the hinges off and carefully bending them a little at a time until I got them right. It took many iterations of trial fitting before I got them not to hang up while making sure the edges of the glass did not contact the body panels. They still leak a little but not as bad as at first.

Good Luck.
 
Last edited:
Back
Top Bottom