Rear sway bar

[Pighead]

Well, thanks, but I did not do the fab work...That's FC187 (on this board), of FC Fabrication in Stockton, CA. I just had the good luck of being one of his first customers.
That's the stock semi-floater, here's the other end of the traction bar...

x2 - nice fabrication and very clean! That's a semi-floater axle right?

Could you post a pic of the attachment for the other end of the traction bar?

 

[bustanutley]

I would suggest using an antirock setup, must cleaner than other factory options, and necessary if you ever link your rear end.