Learned a lot from ih8mud about my FZJ80 so...87245-60430 is the oem part number I used to get the clean look. I believe it is from a diesel 80 if I remember correctly, and it is not available through Toyota in the US. I got mine for approximately $30 shipped from Japan.
Rear Heater Delete Hose with a Factory look
- Thread starter LandCruiserPhil
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
What size breeze clamps are you using?
What Size breeze clamps are you using?When deleting the rear heater on an 80 series there a few ways to address the heater hoses. We at LCP offer a hose in both OEM or Gates for a factory look. Normally we are strong OEM supporters but because this hose see no high heat, vibration, and easy to get to we recommend the Gates hose considering the cost difference.
Both OEM & Gates hoses are in stock and ready to ship.
View attachment 1784066
One of the common ways the hose is addressed. Meh at best
Pictured below the old way
View attachment 1784068
The new and factory looking set up using the hose we offer below. MMmmm
note- it looks like the hose contacts the valve cover but its just the picture angle.
View attachment 1784069
To purchase click ► Rear Heater Bypass Hose - Land Cruiser Products - LCP
What you will receive is pictured below.
Pictured is the Gates hose MADE IN USA
View attachment 1784070
Whatever i had! Lol 2 different sizes. Its 5/8” id hose, so i think 1” clamps. Cant recall. I had a pile of clamps and just dug out what i thought would fit
I will be ordering this from you shortly @LandCruiserPhil You offer a "complete" kit. Where does the straight hose go? Obviously my truck is not in front of me at the moment to attempt to figure it out.
- Thread starter
- #26
Pictured is the hoses that you installing. The clamp you receive are Breeze 9210 Aero-seal liner clamps not the pictured clamps. We also now use Gates Green Stripe hose.
Rear heater delete kit - everything you need (complete)
Rear heater delete kit - everything you need (complete)
- Thread starter
- #27
Breeze 9210 Aero-seal Liner clamps
- Thread starter
- #28
Rear heater delete hose back in stock
sites.google.com
LCP - Rear Heater Delete Hose
Molded Rear Heater Delete Hose The upgraded installation with a perfectly molded hose.
- Thread starter
- #29
We are currently working on putting together kits again.
Is this good for FJ80 and FZJ80?
- Thread starter
- #33
Take the same picture on your FJ80 and post it
Not knowing much about the 1fz, I believe this is the same area of a 3fe.
- Thread starter
- #35
Looks like it will work. If it doesnt I will offer you a full refund
- Thread starter
- #36
Complete Rear Heater Delete kits in stock
All Made in the USA
sites.google.com
All Made in the USA
LCP - Rear Heater Delete Hose
Molded Rear Heater Delete Hose The upgraded installation with a perfectly molded hose.
I just noticed the 1fz heater valve is DS to PS and the 3fe is PS to DS. At least per the photos. Is that a thing?
Just placed an order as my line under the truck started leaking which emptied my entire cooling system.
