Real time Help Changed Plug wires and...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2006
Threads
138
Messages
843
Location
Tierra y Libertad
this morning I changed the plug wires, along with an oil change....

I was thorough in the changing of the plug wires to make sure each plug end went into the right distributor cap receptable...

After I put everything back in it's place i took the rig on a short drive and noticed that:
Even though the truck idles fine (RPM range where it should be...) no erratic idling...

The shift points seem a bit higher than before....the truck wants to shift close to 3K RPMs

From a stand still it seems the transmission is lazy to engage....I may even have heard a sound that wasn't there before...

WTF?

What could be happening?
 
not to imply anything about your mech skills - maybe the PWR button is pushed and it normaly isn't?
 
Unless its part of the ECUs learned behavior, I dont see a connection between spark and shift points. I thought they were RPM based. You probably are getting more spark now.

Disconnect your battery for a bhit to clear the ECU just in case


Check your transmisson fluid as well. had a shifting issue with the 4runner and it turned out to be a little low on fluid.

I really dont know what is causing this, just thought I would give you what I would try.
 
Could an overtighened throttle cable have anything to do with it? I did loosened, then re-tightened to get to the plug boots...
Cable A on this pic which I borrowed from a previous post...
tbcables.webp
 
One of those cables I believe sets the pressure for the transmission clutch. If its not adjusted right the tranny will either slip or be hard to shift
 
You should have an FSM, if not here is the adjustment
Untitled-1 copy.webp
 
Thanks Romer. I disconnected the battery, then checked the tranny fluid level and sure enough it was low. I topped it off, went for another drive, and everything seems to be back to normal, It could have been due to this.
 
Back
Top Bottom