Quick question: brake change

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2014
Threads
24
Messages
88
Location
Los Angeles, CA
Hey guys I am about to change front brakes to 100 pads. Question is do you all get the discs cut(resurfaced)at every brake change or only when you feel a a wave in the discs? Money is tight and the cost of new bearings and the plus the cost of cutting the discs and new bearings and races is out of the question at the moment. Thanks in advance
 
Only when needed, and by then they are usually out of spec anyway and have to be replaced.
 
Unless they have been run dry or way loose for a long time, most of the wheel bearings we have seen look just fine when they are cleaned up and inspected. Reload them with a few $$ of grease if they look good and re run them.
 
Unless they have been run dry or way loose for a long time, most of the wheel bearings we have seen look just fine when they are cleaned up and inspected. Reload them with a few $$ of grease if they look good and re run them.
Was hoping I'd just be able to repack them. Unsure if the machine used will damage the races.
 
I have never resurfaced rotors. Have always just replaced when they get bad.
 
The off vehicle brake disc lathes use soft mandrels, so no, your bearings cups won't be damaged. Even better, have them turned on the truck. Much cheaper and quicker.
 
Yeah, and it's cheaper than pads. Everywhere.
 
I'd actually be surprised if you could find a shop that uses brake lathes anymore.
 
Yeah, and it's cheaper than pads. Everywhere.


This is how they do it on big trucks.

However, most shops do remove/replace on the rotors. I don't know if any standard automotive shops even own the on-car brake lathes anymore.

If money is tight and the rotors are "clean", install new pads. However, if your truck currently has 80 pads, then I would probably go back in with 80 pads because the surface area on a set of worn rotors will be worn and rusted to match the 80 pads, not the increased size of the 100 pads.

Make sure you "bed" the brakes when the new pads are installed. This sets the resin and will stop the squealing. It can also straighten warped rotors.
 
Make sure you "bed" the brakes when the new pads are installed
This is very good advice, that most installers don't go to the trouble to do this.
 
Just an afterthought, some brands of brake pads come with a highly abrasive surface, the first few brake applications take out minor ridging, also if brake discs are bad enough we replace, machining brake discs is a thing of the past.

Regards

Dave
 
Back
Top Bottom