Questions on U-Joint Spider Replcmnt

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 23, 2007
Threads
114
Messages
1,115
Location
Kennett Square, PA
Website
cruisin4parts.com
My 80 has 210k miles and has never had any drive line work, so its no wonder I have to replace it now.

My father says its easy, you ratchet them out, take them off, replace the spiders and pop the back on.

I said, I have to worry about the phases and alignment right?

No way, just put them back on.

My father knows a lot. A whole lot, but I think he could be wrong here.

When I take off the shafts and put them back on what should I look out for?
 
Mark the orientation of the two halves of the driveshaft to get the yokes back together the same. Take a few digital pics as you go for double checking yourself. My marks all ended up wiped off, but I knew the correct orientation and all went well. I've always heard the flanges should go back on in the exact same orientation, so make an effort there. Is your dad going to help with the bearings? Everything I heard here indicated it would be simple, but it was a little tough getting things apart and back together. Someone who's done it before would've helped, maybe I wouldn't have taken a month to get it done.
 
If you remove the driveline and DO NOT pull the slip yoke out, keep it in one piece. then take apart one end and replace the u-joint and then you can work on the other end... Finish the end you started on before you touch the other end.. you will run into problems if you slip the driveline apart into 2 halves and then take out both u-joints so that you have a pile of parts and no clue how they go together...
later
 
Yeah, my dad and his worker are going to give me a hand. I have to do all the dirty work (getting them off) and he's going to show me how to do the bearings and stuff.
I think they are definitely gone now. Driving home it went from some vibrations to a terrifying whirr when it was let off the pedal.

Where should I buy the parts? I have a local Toyota Dealer who has a good parts counter but I don't want to over pay.
 
Someone who's done it before would've helped, maybe I wouldn't have taken a month to get it done.

It only took a month because you carried the shaft around in your truck for 27 days................:D
 
It only took a month because you carried the shaft around in your truck for 27 days................:D

True 'nuff. I worked on everyone else's cars, put in a lot of overtime, vacationed up north, all with that driveshaft in the back of the truck.
 
Back
Top Bottom