Question about secondary lighting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 5, 2016
Threads
10
Messages
96
Location
Maryland
My 1990 JDM 80 series LC has what look like driving lights mounted inboard of the headlight units; they don't switch on. They are not the high beams- both high and low beams are in the headlight unit, most likely in a two-filament bulb like an H4. The owner's manual is present, but is in Japanese, which I don't read or speak, so it isn't any help.

I think these are driving or fog lights. If anyone can tell me how they are supposed to switch on, I'd appreciate it.
 
P4194780.webp
P4194781.webp
 
Here are some photos, one each side. The outer and wider lamp assembly is the headlamp, both high and low beams. Those work fine. It's the inside lamp, the ones closest to the grille, that I can't get to light up.
 
Any comments? I've been told these are actually aftermarket lights put on the car when it was in Japan. Any info would be useful. Thank you.
 
On the stock 80 the inner beams come on with main beam, i.e. FOUR headlights at the same time. They do look like aftermarket units, either way, the wiring is not there or both bulbs are blown.

The 80 is known for burning out the headlight relay in the box on the inner wing, some remove the inner lamp bulbs/wiring to reduce the load on the relay.

regards

Dave
 
The diffuser cap is missing on the inner beams. Looks like they could also be missing the bulbs. Hard to tell from the pic. Definitely aftermarket and as @Dave 2000 mentioned, they are probably disabled for a reason.
 
They do have bulbs in them. Since I didn't buy them new, and they were there when the truck came over from Japan, I don't know what they are supposed to look like. I'll try to figure out the wiring. It sounds like they would need their own relay, though.
 
Those look like DEPO aftermarket headlights. I have a set that look identical. Mine do not have a "diffuser cap" as @SUMMIT CRUISERS mentioned. The outer should be a H4 dual filament with the inner a H1 bulb. It seems like most of the DEPO users here use the H4 as their low beam with the H1 wired for their high beam. However, the inner H1 bulb on the DEPO is more of a spot driving light. So, perhaps the PO of your vehicle had them wired as such and removed the switch and associated harness. If the are DEPO's and you want to take advantage of the dual filament H4 and the H1 bulb you may find some useful info here:

DEPO Lights with a Slee Harness
 
I think what I'd like is for the H4 light to operate the way it's supposed to- either the low or high filament, but not both, and for the H1 light to be on its own switch and relay. I am going to try to wire them that way.
 
Back
Top Bottom