Pyro Installation... Location Location Location ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 4, 2008
Threads
55
Messages
210
Location
Mission BC
OK I've searched, and googled, but haven't found any information on where on my 1HD-T to mount my Pyrometer. I'd like to mount before the turbo, but how many :banana:is that job? Is it worth the effort mounting it preturbo?
If I laze out and chose postturbo, where would be a good place? Any caveats before I proceed? :idea:
 
I'm not sure if you have but you might also want to post in the deisel tech section. sorry no answers for you.
 
Here's a visual
1HD-T pyro location.webp
 
that's where I mounted mine
be forewarned that with the turbo in place and various other bits there, it was difficult to spin the tap effectively.

Removing the exhaust manifold from the truck would make it easier, but that's a lot of work.

I used a magnet and a vacuum cleaner to keep steel shavings out of the pipe as I drilled/tapped.

I think that all in all, I might pull the exhaust manifold out to install a new pyro. Maybe.
 
I pull my exhaust manifold to do the job .. one day job .. need 2 persons to make it more easy, you have plenty of space on the exhaust side, but it's heavy and hard to aling the bolts alone ..

even without the turbo attached ..
 
:bang:Argh!!

I knew I'd have to take that manifold off. I do not trust myself not to drop some shavings into the manifold, even if others can do it, I know myself to well.

Thanks for the tips.:beer:
 
for those that do decide to drill with the manifold on the truck, you can do it while the motor is idling, so that any chips/shavings will be blown out instead of fall into the turbo.

Still, it isn't easy to get a tap in there, and it is a hot job unless you move fast.
 
That gives me the heebie jeebies. I can just picture the tip of the bit breaking off and dropping into the turbo.

Really you want to pull the manifold so that you can
acurately adjust the depth of the probe AND
then you can bling it up with some Ceramic coating while it's off too.
1HD-T CT26RB.webp
 
sure.... "while you are at it" you can do a lot of things

As I said, I drilled on the truck. Took me freaking forever and I wasn't very comfortable (hot, sucking exhaust fumes).

The more I think about it, I'm sure I'd pull the manifold off to do the job again. Would also be a good time to replace the oil hose to the turbo and/or the coolant hoses. If you are there anyway.
 
Yup, good call. The original oil feed/dump assy's had a tendancy to crack where the feed tube is welded to the base. The subbed up part number 15407-17011 has a longer oil feed tube bent at more acute angle to absorb the vibrations better. Good idea to replace lest you pump out all your oil on the highway.
 
Back
Top Bottom