Pulling front 3rd - time for axle rebuild?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 1, 2016
Threads
13
Messages
95
Location
AK
Hello all,

So I'm still in the process of base-lining my new to me 94 LC. Its been way more work than I'd like it to be, but thats a story for another day.

I am in the process of pulling my front 3rd member to send it to ZUK so he can fix whatever is going wrong in there. Of course that means pulling the axles and all that jazz. The PO said the front end was serviced about 10k miles ago - and I believe him, the grease looks pretty fresh in there. The one thing I don't like is that I will never be able to find the same grease that was used, so I'll end up with two different kinds in there. Unless I just go ahead and do a full rebuild again. I'm leaning towards rebuild - as I need to clean grease off the birfs and everything else good so I can see what condition they are in. I've never pulled the knuckle portion apart though and wondered what everyone's opinion might be.

Thanks
 
If you're pulling the 3rd, then you're already pulling everything apart. What are your choices? You plan to pull everything apart and then just slap it all back together? That makes no sense.
 
I did not need to pull the knuckle(?) portion apart to get the birfs/shafts out. But a guy can't really get all the grease out of them without pulling them off. It kind of sounds like I'm answering my own question here. I should just do a full rebuild.
 
Sometimes you just need to talk this stuff out to see the full picture.
I think you've come to the correct conclusion.
 
Definitely pull it all down, inspect everything, clean and reassemble (replace any worn parts). That way you KNOW the condition and can be confident everything is right and will give you good service for years to come.

Until you pull the steering knuckles and look at the caps and bearings you can't know their condition or the condition of the races.

Assembled....all you can do is check each knuckle for slop/movement.

Replace any seals in need of attention (I would do all of them regardless) and when your 3rd comes back....you're good to go. Except to replace the gear oil from time to time and top off the birf grease....you won't be going back into the front axle for a LONG time.
 
Back
Top Bottom