- Thread starter
- #61
Just saw your post. I'm in the private sector now doing work on older cars and 4x4s.
No data on the site, just a link http://bullsac.com
Build Project: Colonel 1979 FJ40
- Thread starter bull
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Just saw your post. I'm in the private sector now doing work on older cars and 4x4s.
No data on the site, just a link http://bullsac.com
- Thread starter
- #62
- Thread starter
- #63
Added a "in" the cab winch control.
checking for the best wiring route.
gran pappy making the first cut
Squaring it up
Rocker switch..up out / down in
checking for the best wiring route.
gran pappy making the first cut
Squaring it up
Rocker switch..up out / down in
From the side, you look just like Alan. 
checking for the best wiring route.
checking for the best wiring route.
- Thread starter
- #65
From the side, you look just like Alan.
checking for the best wiring route.
Yes he is my shop bitch!
- Thread starter
- #66
Added a H41 with split case. Going to deal with no parking brake shortly.
- Thread starter
- #67
Just finished painting my pakistan half doors and tailgate.
Test fitting
pics
There were some cracks from where the two panels were welded together. Ground them down and fixed it.. A little bondo makes everything nice!
Ready for some wet sanding
Test fitting
pics
There were some cracks from where the two panels were welded together. Ground them down and fixed it.. A little bondo makes everything nice!
Ready for some wet sanding
- Thread starter
- #68
Before wet sand..more to come
- Thread starter
- #69
Here is an semi-updated pic of the colonel mustid.
Are those 34x10.5 LTB's on stocker rims?
Was wondering if I could pull that off.....
Was wondering if I could pull that off.....
- Thread starter
- #71
Oh yes you can! I used equal balancing powder and the run fine..
- Thread starter
- #73
Equal http://imiproducts.com/equal/tire-balancing.aspx
2.5" OME lift, but I will probably need to trim or go a bit higher. The problem is that I don't want to go much higher due to the trails here in the NW. All the off camber trails == huge pucker factor and or flopping.
2.5" OME lift, but I will probably need to trim or go a bit higher. The problem is that I don't want to go much higher due to the trails here in the NW. All the off camber trails == huge pucker factor and or flopping.
- Thread starter
- #76
It is a powder you put in your tire that helps it balance out. The tires are big and biased ply so they don't vibrate etc. see link above..
Cage was bought at Metal-Tech $700-$800 I think.
Doors
I would like to know more about the half doors. I have an extra set and would like to make them turn out like that. They look sharpe!
I would like to know more about the half doors. I have an extra set and would like to make them turn out like that. They look sharpe!
- Thread starter
- #79
Eshan made the half doors. They have the pimp ass canvas uppers.
I can take whatever pics you need and give you dimensions too.
I can take whatever pics you need and give you dimensions too.
very nice. truck looks mean with those meaty tires.