Power Stering Pump Rebuild Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 1, 2006
Threads
104
Messages
573
Location
North Jersey
I just figured I ask what went wrong with my rebuild. I had a leaky PS pump and rebuilt it with the kit and new bearing from CDan and now it has a ticking whining noise but steers fine and the noise disappears when under load. I can't understand what I screwed up I did it along with a complete top end rebuild which turned out perfect but the PS rebuild did not. I first used synthetic PS fluid then added Downy finally flushed it all out and used Shell dino ATF noise still there. I might just wait till it dies but I really hate the noise it makes I thought I had a rod knock after getting it back together until I discovered the source (big sigh) Anyone have a rebuild go bad like this?

Thanks
George
 
I did, but not in the later model 80s. I rebuilt my 91 pump and one of the vanes in the pump was put in wrong and it made noises...
 
I did, but not in the later model 80s. I rebuilt my 91 pump and one of the vanes in the pump was put in wrong and it made noises...
Dan,

I was suspecting the vanes too, but I checked and rechecked that all of the beveled edges were facing out before I closed it up, but could be wrong just hate to rip it open again its a mess! The new and old style pumps are the same inside except for the drive method could I have put it together to tightly? With that one vane in backward did you do any permanent damage? I've put about 700 miles on it.

George
 
Back
Top Bottom