power steering up grade

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 25, 2005
Threads
29
Messages
132
Location
Huntsville,Tx
I am trying to up grade my powersteering that PO installed (u joints sloppy) Here are the dementions 35.5 in long,36 spline @ gear box, double D@ gear box end, round shaft @ firewall end with DD coupler from DD to round shaft. There are two universals one (hidden in a boot @ gear box end) and the other about 4 in from fire wall. I tried to talk to the people @ summit but they said that they would have to build one for me.

So here is my Q. Isn't there a set up out there that someone has done already that I can get for my truck?

I can, and do have a welder,although Summit cringed when I told him that there was a weld in between the u joints.
Any thing would be better than what I have...NO steering, and I can't drive my truck:crybaby:

Thanks in advanced for anything
 
Hi All:

Give a call to BTB Enterprises; they sell parts for the Saginaw PS swap. They can supply you with a replacement steering shaft. <http://store.btbprod.com>

If you are interested, I can supply you with a list of parts you can acquire to fab your own steering shaft. "PM" me your e-mail address if interested.

Regards,

Alan
 
alot of companies have complete kits, as stated, BTB products, man-a-fre, sor are just a few. good luck
 
Trying to understand what you are saying.
The DD shaft attaches to a U-joint at the saginaw box? Is it a borgeson joint?
You have another U-joint 4" from the fire wall. What type is that joint?
If both are double DDs, then just get a round shaft, the right length, grind down the ends to fit the DD. Drill a little seating hole for the set screws. Put it together with some locktite on the set screws. That is what I did 8yrs ago and still running it.
 
thanks

I know it sounds confusing...the PO did this so who knows what type of joints they are.

I just called Flaming river and they were very helpful (unlike Summit)
they are going to send me a ujoint that is round on one end, then drill it with 5/16 drill. Then use 5/16 bolt /locktite./they are going to send me universal DD shaft 36" might have to be cut down.
The other end is going to be DD with u joint to 36 spline with locking pin.

I will have it in 10 days, I am not the best with picts. but I can try to take before and after...
I will keep y-all informed
thanks again
Dennis
 
lets see picts???

Sorry can't figure out how to send picts.
if someone can help an idiot with computers by all means do!
 
Back
Top Bottom