Power steering pump leak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hey guys - just dug this thread up - because my power steering pump cooler lines appear to be leaking. I thought they looked wet a few weeks back - and then I started to hear the moan from the pwr steering pump. Dont know if it's as simple as an o-ring - or the whole line (they look REALLY rusty).

But the question asked above was never answered. How much cooling does the pwr steering fluid need? Could you bypass the cooling lines in the winter and repair when the warm weather returned?

Where in NJ are you? I'm heading to Manhattan on Monday and have a good factory cooler sitting in my garage.
 
I love the design of this hardline being the "cooler"! :rolleyes: Has anyone just bypassed this cooler hardline? Does the PS fluid need a significant amount of cooling? If so, has anyone ever mounted a aftermarket oilcooler and plumbed the PS fluid through there? Hmmm. :idea:
Mine went earlier this summer. I bought a small trans cooler from summit racing (roughly 3" x 12") to use as a replacement. I sawzalled the OEM cooler lines inside the engine bay, mounted the trans cooler on the crossmember (basicly in the same location as the OEM setup), and plumbed it with 3/8 line. Not only is it a more effective cooling device, it holds much more fluid as well. I have no more that $50 into all the bits, shipping and running around. I can take pics if needed.Clint-
 
Mine went earlier this summer. I bought a small trans cooler from summit racing (roughly 3" x 12") to use as a replacement. I sawzalled the OEM cooler lines inside the engine bay, mounted the trans cooler on the crossmember (basicly in the same location as the OEM setup), and plumbed it with 3/8 line. Not only is it a more effective cooling device, it holds much more fluid as well. I have no more that $50 into all the bits, shipping and running around. I can take pics if needed.Clint-



pics.......please! :D
 
Where in NJ are you? I'm heading to Manhattan on Monday and have a good factory cooler sitting in my garage.

Sorry - I missed your post. Westfield NJ - but I work in Manhattan.

Far as I can tell - its just the line rotting out. I'm gonna crawl under there again tonight to tell for sure.
 
Far as I can tell - its just the line rotting out. I'm gonna crawl under there again tonight to tell for sure.

If the line is rotting out here in sunny NJ, it's due to salt corrosion. You will likely find that the exposed part of the line is not what's rotted, but the part that bends around and over the crossmember and is clamped down on the DS. If so, you'll need either to replace the entire line, or replumb from the pump to your new cooler.
 
I just replaced that PITA cooling line. While talking to C-Dan... how much cooling does the Powersteering system need, how little cooling...

I went with the stock replacement, bolts up into factory locations. 6 hr job. getting the radiator out is a bear at times, best to pull the headlights to help get the rad out, I know seems odd.

I paid just shy of $300 for the cooler and then another $100 to have my a/c recharged after I confused the FSM, whoops!!!!:doh:

A second set of hands helps out and someone that has pulled the radiator will help as well.
 
Ok - that doesnt sound like fun. Time to maybe think about an external cooler idea. I dont have 6 hours to spare - or the money at this point.
 
Back
Top Bottom