Power steering Bleed.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

RFB

97 FZJ80 LIFTED SC DUAL BATTERIES,37s
Joined
Mar 7, 2017
Threads
353
Messages
3,748
Location
Nahant Ma.
Website
www.youtube.com
Ok Ive done this before, Im htting the highway soon and happened on a used steering gear off a fellow MUD member. Mine leaks and today I figured Ill swap it in real quik and bleed. Ive been bleeding all day its pouring cold rain and still NADA Shes up on stands SS is disconnected 50 times around engine off, and then with engine on a few lock to locks real slow. But its been 6 hours and shes tighter than a bullfrogs arse. What am I missing. besides the obvious headgasket.
 
Did one that was troublesome the other day. Typically your method works perfect.

What i do that is a little different is don't go full lock when you turn the engine on for 10 times. Then have someone with flashlight and oil there watching the level. it will pull it empty very quick, and it likely will overflow at lock, so it takes some patience.

We had to do it 3 cycles to finally stick. So 20 times back and forth off, then 20 times with engine on - don't go full lock. Then 20 times at full lock, then back to off, then on, then off, then on.
 
  • Like
Reactions: RFB
We did it after a full set of hoses replacement with 100 lock to lock SLOWLY with it on stands and engine OFF.

Then we did it 100 MORE times lock to lock SLOWLY with it on stands and engine running. Had to check fluid after every 10 cycles.

Don't HOLD it at full lock either direction while running, it will spew forth as 2fpower stated.

We used Dexron 3 equivalent. (FSM calls for this)......Others use Mobil DTE Hydraulic.
 
  • Like
Reactions: RFB
We did it after a full set of hoses replacement with 100 lock to lock SLOWLY with it on stands and engine OFF.

Then we did it 100 MORE times lock to lock SLOWLY with it on stands and engine running. Had to check fluid after every 10 cycles.

Don't HOLD it at full lock either direction while running, it will spew forth as 2fpower stated.

We used Dexron 3 equivalent. (FSM calls for this)......Others use Mobil DTE Hydraulic.
Ill hit it again in AM Im using toyota ATF dex 3 I forgot how bad this is. thanks gentlemen
 
We did it after a full set of hoses replacement with 100 lock to lock SLOWLY with it on stands and engine OFF.

Then we did it 100 MORE times lock to lock SLOWLY with it on stands and engine running. Had to check fluid after every 10 cycles.

Don't HOLD it at full lock either direction while running, it will spew forth as 2fpower stated.

We used Dexron 3 equivalent. (FSM calls for this)......Others use Mobil DTE Hydraulic.
I think that was my mistake I cranked it to lock while running I kept a rag over it so it didnt blow all over engine. it could breathe though I appreciate the intel guys.
 
Back
Top Bottom