Pipe size for separating birf from axle.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2011
Threads
144
Messages
1,243
Location
Long Beach, CA
I tried doing a search but couldn't find what I'm looking for. Does anyone have what the overall length and I.D. need to be for separating the birf from the axle shaft? I'm helping a friend do a knuckle rebuild this weekend and would like to swap birf's as well.
 
I went to Lowes and got a 1.5" PVC pipe. It came in a 5 foot length. Worked well, but my driveway has craters filled with moly grease now.

Also, don't forget to order the circlips. They can break.
 
I went to Lowes and got a 1.5" PVC pipe. It came in a 5 foot length. Worked well, but my driveway has craters filled with moly grease now.

Also, don't forget to order the circlips. They can break.
Already have the circlips. What wall thickness PVC did you use? I'd like to find something in metal because after I do my friends 80 mine is next to get a knuckle rebuild and birf swap so I'd like something that will last more than once.
 
Already have the circlips. What wall thickness PVC did you use? I'd like to find something in metal because after I do my friends 80 mine is next to get a knuckle rebuild and birf swap so I'd like something that will last more than once.

PVC works just fine. Length is more important than thickness....If I had a nickle for every time.
This job is best done with 2 ppl. Have 1 person hold the Birf Joint. Other person puts 2 hands on pipe and slam the end on the ground.
Once you know how to do it, job takes about 1 min.
Would not do a Axle rebuild without switching them and moving wear area.
Stuff a rag in pipe end opposite the BIRF, to keep axle from slamming the concrete.
 
Already have the circlips. What wall thickness PVC did you use? I'd like to find something in metal because after I do my friends 80 mine is next to get a knuckle rebuild and birf swap so I'd like something that will last more than once.

Schedule 40, the normal white stuff. My pipe wasn't damaged by the procedure (I still have it in the garage), and anyway I'd rather damage the pipe than have a steel pipe scrape up the machined surfaces of the axle (particularly the oil seal surface)
 
PVC works just fine. Length is more important than thickness....If I had a nickle for every time.
This job is best done with 2 ppl. Have 1 person hold the Birf Joint. Other person puts 2 hands on pipe and slam the end on the ground.
Once you know how to do it, job takes about 1 min.
Would not do a Axle rebuild without switching them and moving wear area.
Stuff a rag in pipe end opposite the BIRF, to keep axle from slamming the concrete.

Schedule 40, the normal white stuff. My pipe wasn't damaged by the procedure (I still have it in the garage), and anyway I'd rather damage the pipe than have a steel pipe scrape up the machined surfaces of the axle (particularly the oil seal surface)

Thanks for the tips and I will have someone helping me with the rebuild so it goes quicker.
 
You can accomplish the same thing with a 2x4 instead of a PVC pipe, if you have one sitting around.
 
Back
Top Bottom