Pertronix Trouble

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2004
Threads
52
Messages
880
Location
Olympia, WA
Hi all,

Perhaps this has been asked and answered (though I could not find anything in a search). I'm having trouble hooking up a Pertronix Igniter II. The directions really couldn't be much simpler but when I hook it up I get nothing (no spark at all).

The PO installed a ground wire that feeds the gauges from the "-" side of the coil. I'm going to take this off and find another "-" terminal elsewhere or re-establish the correct connection.

Any tips, clues, etc would be appreciated to install the Igniter II would be appreciated.

Thanks, folks!
 
From the website of Pertronix:
Since I have installed the Ignitor™ the engine won’t start. What can I check?

The first step in trouble shooting involves answering a few questions.
Do you have the correct kit for your application?
Did the Ignitor install without any modification?
Was the Ignitor installed according to the instructions?
Did the engine run prior to the installation of the Ignitor?
If you answered "NO" to any of the previous questions, go back and correct the condition before proceeding. If the answer to these questions is “YES”, then review some additional common solutions to a no start condition.
The position in which the Ignitor red wire is attached to is not supplying sufficient voltage.
The air gap between the module and magnet sleeve is too great.
The ground wire inside the distributor is not connected.
The wire connections are not tight.
The polarity is not correct.
 
Doug_S said:
The PO installed a ground wire that feeds the gauges from the "-" side of the coil. I'm going to take this off and find another "-" terminal elsewhere or re-establish the correct connection.

!

The only things that should be connected to the - side of the coil are the distributor (Pertronix ignitor) and possibly a tachometer. If you have a tachometer, it may not be compatible with the Pertronix. Disconnect anything else and try again.
 
Thanks for the advice, Pin_Head. I will disconnect the wire coming from the "-" side of the distributor going to the instruments and give it another try today. I'd really like to get the Pertronix system going.

One additional question: what is done with the wire that originally went to the stud on the outside of the distributor? Is it left out of the Pertronix installation entirely?
 
Doug_S said:
Thanks for the advice, Pin_Head. I will disconnect the wire coming from the "-" side of the distributor going to the instruments and give it another try today. I'd really like to get the Pertronix system going.

One additional question: what is done with the wire that originally went to the stud on the outside of the distributor? Is it left out of the Pertronix installation entirely?

Yes! The black wire from the Pertronix is the only one that should be going to the - side of the coil. Put that wire aside with your old points and terminal block to have in case of emergency.
 
Thanks for the advice!
 
Back
Top Bottom