Performance 1fz build questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 28, 2005
Threads
66
Messages
222
Location
Portland, OR
Website
www.ortiz-myers.com
So i have done a bit of searching and found 2 people who have done builds....none are running yet.

I am unable to find any of Robbie's threads where he talks about headwork.

We have a flow bench and already have H-beam rods in stock for these motors and once head work has been figured will have high compression pistons we will stock.

The goal of the build is Fuel economy, reliability, more torque for towing. In that order.

Our head development has been focused on more low lift flow and less valve turbulence.

Any suggestions or thoughts would be appreciated.
Jonathan
 
with my 2f 3E That I have been building the whole purpose has been to get 22 mpg. So all the headwork and pistons have centered around.

We are bring the same to 1FZ and hope too get 20+ while not towing. Centered on some super efficient valves and some fast burning chambers we will see what we can do.
 
thread diversion

with my 2f 3E That I have been building the whole purpose has been to get 22 mpg. So all the headwork and pistons have centered around.

Is this something still in the works or do you actually have it running? What is this engine in or going into?
 
its still being built. I almost have the engine done...but the truck is not ready for it yet....not sure what to do, we may just dyno test and tune it on the engine dyno and call it a research project and wait for my grandfathers 40 to be ready for it.

The pistons are done and the headwork is complete....welding and grinding cast iron is not fun!!!
 
Back
Top Bottom