Penetrating Oil VS. RUST?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2003
Threads
323
Messages
5,695
Location
Southwest Oregon
Ok so I tried PB penetrant and liquid wrench and after a lot of work I got my 8274 apart but one portion of the inner shaft was still seized up and I ended up using CASTROL SUPERCLEAN to get that apart, it seemed to eat the rust or at least get it loose.

What works best for you to free up rust bound parts and pieces?
 
IDave said:
Here

Link certified TUT free by this guy
avatar7463_17.gif
 
Hmm. You were right. :D
 
I'm a firm believer in Tri-Flow

.... anything that will run up into a bolt defying gravity.... :D

seriously.... try it... you'll like it!
 
Kroil. Works, smells and tastes better than PB or WD.
 
I've found heating a bolt and or nut up with the torch will help break it loose faster than anything, of course if your near the gas tank or its next to something you don't want to melt then it doesn't work so well.
 
I've found that nothing would free the bolts from my fenders. Some just plain broke, others had to be cut, I think 1 in 10 actually came free by working it back and forth and spraying PBB.

In the end - Rust wins. Cut 'em, drill out the old, run a race through the nut and put in new bolts.
 
Hi All:

I'll second "IDave's" suggestion of Kroil: it is quite expensive but works where other pentrating oils won't. Also, I a small amount goes a long way.

I'd also say that "Rustred40" has an excellant point; heat often helps loosen rusted-in bolts.

Regards,

Alan
 
Yep, heat and hammer(brass & lead) were applied. I haven't seen Kroil in a store but I will keep my eyes open.
I used to use triflow for my skate board bearings, good stuff agreed.
Zep makes a good penetrant too but didn't look for it, Tech 2000 at Wally-World smells just like it. Don't like going there tho'..
 
I agree with dave use kroil. Thats what we use where I work and we are always working with rusted parts coming from the coal mine. My brother bought an old hit and miss farm engine that had 40+ years of rust on it and we filled the cylinder with kroil for a month and the piston freed up. Its kind of expensive but you can buy it in gallon cans, it has really work wonders and is better than wd40 and other penetrating oils
 
Back
Top Bottom