Peeling weather stripping fix

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 5, 2008
Threads
53
Messages
121
Location
Western Washington
image.webp
Guys,
Getting around to building the truck and fixing the little stuff. The "blackout" stripping covering the chrome below the windows is peeling up. Take a look at the pics and let me know if you have a replacement or a fix. The thumbnail is what it should look like. Thanks.
image.webp


image.webp
 
Would also like to know about replacing. After 20 years, they are starting to crack. Wouldn't remove them, I'd be scared water could seep in or could add some road noise.
 
I have the same problem too. I am just going to replace them with new one. I believe it is around thirty dollars a piece, should be less with mud vendor.
 
So is this not a trim piece for ascetics? I was under the impression that this was only for looks; does removing this really open it up to water seepage?
 
New weatherstripping is still available AFAIK and comes with new clips. The weatherstripping is very important IMO, it limits the amount of water and noise from entering the door cavity, and noise that gets inside the door is transmitted into the cabin. Water that gets into the door will damage the speakers (more than usual) and can get into the wiring harness IME. Some water normally trickles past the edges of the weatherstripping and drips out the drain holes at the bottom of the door.
 
I looked into this issue last week. This is what one of the mud venders quoted me. I was considering just removing them.
75710-66021 $56.42 RF belt molding
75720-66021 $56.42 LF belt molding
75730-60020 $56.68 RR belt molding
75740-60020 $56.68 LR belt molding
 
I looked into this issue last week. This is what one of the mud venders quoted me. I was considering just removing them.
75710-66021 $56.42 RF belt molding
75720-66021 $56.42 LF belt molding
75730-60020 $56.68 RR belt molding
75740-60020 $56.68 LR belt molding

For those prices, I'll prob stick with my cracking weatherstripping until it fails. I don't think it looks all that bad anyways, and it works.
 
I looked into this issue last week. This is what one of the mud venders quoted me. I was considering just removing them.
75710-66021 $56.42 RF belt molding
75720-66021 $56.42 LF belt molding
75730-60020 $56.68 RR belt molding
75740-60020 $56.68 LR belt molding
Are these prices just for this strip in question? This is getting expensive to replace weather stripping.
 
If you take them off it will sound as if you're in an airplane with all the wind noise. Also be VERY careful removing the trim. The plastic clips that hold it in place are probably very brittle by now. If you break these, the trim won't sit tight against the door and you'll get noise/water in.
I looked into this issue last week. This is what one of the mud venders quoted me. I was considering just removing them.
75710-66021 $56.42 RF belt molding
75720-66021 $56.42 LF belt molding
75730-60020 $56.68 RR belt molding
75740-60020 $56.68 LR belt molding

You can get them a few bucks cheaper on any online Toyota parts site.
 
You can also buy the clips if you break them in the process. $2.35 each, about 13 total per side. So figure about $60 for new clips.

208685563.png

Thanks for this info, this is really helpful. I am by no means, in any way, even close to being considered a novice wrencher, but to me it looks like the pieces in question are trim just like the other pieces on the above in the pic. I thought the chrome pieces underneath were the "working pieces" if that makes sense. But like I said, I rely wholly upon others with much greater knowledge than mine. You all know alot better than me.
Crazy those little pieces do that much.
 
Thanks for this info, this is really helpful. I am by no means, in any way, even close to being considered a novice wrencher, but to me it looks like the pieces in question are trim just like the other pieces on the above in the pic. I thought the chrome pieces underneath were the "working pieces" if that makes sense. But like I said, I rely wholly upon others with much greater knowledge than mine. You all know alot better than me.
Crazy those little pieces do that much.

I can't remember, I'd have to look at them again. I'm not sure if the black rubber coating is attached to the seal at the back of the trim. Or perhaps could take a hobby knife to it. Just trim away the exposed black rubber trim, making sure not to mess with the part that sits against the window...
 
Last edited:
I can't remember, I'd have to look at them again. I'm not sure if the black rubber coating is attached to the seal at the back of the trim. Or perhaps could take a hobby knife to it. Just trim away the exposed black rubber trim, making sure not to mess with the part that sits against the window...
Jose, where did you buy the clips individually? I checked at the dealer who said they only come when you order the entire belt molding.
 
Contact a MUD Toyota vendor ("Cruiserdan", Dan, American Toyota, NM or "Beno", Onur, Nalley Toyota, Georgia, and others) they will be able to get those clips for you.
 
Back
Top Bottom