Painless Wiring Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

If you are not going GM steering column, hazards, turn signals and lights, then keep the cruiser wiring to these circuits. Just wire the Painless feeds from the fuse block to the hazards and turns as shown in the cruiser schematic. You might need to change the existing terminal ends to make them more reliable, but chances are that the wires themselves are OK. Trying to make the Painless GM wiring work with the cruiser hazards, turns and brakes is too big of a PITA.
 
Back
Top Bottom