Overheating

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 6, 2019
Threads
1
Messages
6
Location
Georgia
Hi folks, I have a 1997 Land Cruiser. It’s been running hot. Radiator is a year old, new water pump, thermostat and fan clutch. VSV and EGR solenoid are new. EGR test good. No water in oil or oil in water. Haven’t been losing water until it started boiling out. It has started boiling water without reading hot. Please help because I’m lost.
 
I’ll check that tomorrow. What would it mean? It only started boiling out today. Was reading normal temp but gurgling and boiling over. Would previously register that temp was rising.
 
I’ll check that tomorrow. What would it mean? It only started boiling out today. Was reading normal temp but gurgling and boiling over. Would previously register that temp was rising.
I the p0401 code went away when I changed the VSV
 
I'm sorry, but this does not sound good.
 
I’ll check that tomorrow. What would it mean?

It would mean a blown head gasket. Relatively expensive to repair unless you do the work yourself...luckily, well worth repairing if your 80 is nice as it is a known (higher mileage) issue, Toyota redesigned the head gasket so it likely won’t happen again and makes your rig much more marketable should you ever decide to sell.

So, silver lining to what I see as an inevitable dark cloud of 80 ownership.
 
It would mean a blown head gasket. Relatively expensive to repair unless you do the work yourself...luckily, well worth repairing if your 80 is nice as it is a known (higher mileage) issue, Toyota redesigned the head gasket so it likely won’t happen again and makes your rig much more marketable should you ever decide to sell.

So, silver lining to what I see as an inevitable dark cloud of 80 ownership.
I do all of my own work. What’s the best place to buy these parts?
 
I do all of my own work. What’s the best place to buy these parts?
I cranked it this morning with the radiator cap off. No bubbles but it immediately started slowly running over. I let it run, all the way to normal temp and it continued to slowly but steadily run out.
 
I do all of my own work. What’s the best place to buy these parts?


Here is a Toyota dealer that advertises discounts on Mud. I can’t vouch for their Cruiser knowledge or customer service since I’ve never used them...but the fact that they interact on this forum is a good sign.
 
Back
Top Bottom