Ole Red Lipstick

[PabloCruise]

Sumptin wrong wit u

You are seriously just figuring that out now?!?

 

[PabloCruise]

Oh Man! We're all going to the HR office.

 

[PabloCruise]

Cleaned 7 inches of Snow off Red the other day and another 18 inches today and an estimated 4 to 10 on Thursday. Oh and i have pictures Bitches . Will also post Nuts or Balls with each post for all those who have inhibitions View attachment 3228704View attachment 3228705View attachment 3228711View attachment 3228712
View attachment 3228712

If you have 18" Bob, you don't need the She-Wee snorkel! Just flop it out of the RTT...

 

[PabloCruise]

Got sum new emblems fo da hood View attachment 3231816View attachment 3231817View attachment 3231818View attachment 3231819

Do those emblems come w/ the She-Wee snorkel?

 

[bobm]

Hate when they touch the water in da .

 

[Ol Yeller]

So your saying the shorts need to be a bit longer these days? LOL

 

[bobm]

Knee length always . Kilt in summa .

 

[bobm]

You seen my Ground Hog??? . Your Cousin from Boston .

 

[bobm]

Ooohh forgot

 

[bobm]

So, had an issue with my Choke cable and needed to replace it. I wanted the Knob to say Choke like it does now! Got a quote for $184.00 from someone. I'm like what are you ****ing s. So in my Damaged Brain I says I can fix this. So I get started .
Disconnect choke cable at carb.

Remove center dash panel and undo nut holding cable knob.

Now i know what I need, so i go hardware store for a lenghth of .060 ss cable for a grand total of 57 cents WTF. Actually it was Free, because I knew the girl there . I come home and tear into the Old cable.

 

[bobm]

I detached the sheath and pulled the old cable out

 

[bobm]

I cut the end off the cjoke knob.

at that 1st groove in 2nd pic .

 

[bobm]

I then drill out the end of Knob wit .060 drill bit

 

[bobm]

Next, its time to install the new cable and crimp it

 

[bobm]

Time to re-assemble. Feed the new cable through the sheat

 

[bobm]

Reverse the order you went through in dis- assembly

 

[bobm]

Bring the new cable and save the old 1 to feed the new 1 through firewall.

 

[bobm]

Then feed new assembly torough mid panel! Dont forget feeding sheath throgh nut on back of panel like I did.

 

[bobm]

Feed cable through carb linkage 1st and pull sheath throgh firewall.

 

[bobm]

Then finish other mounting points and tighten nut on back of choke cable before installing mid dash panel . Make final adjustments ️