Okay front axle gurus...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Rick,

So you're thinking of pressing a new bushing in, eh? How much are those bushings? On my next repack I'll also be thinking new spindle and the upgraded needle bearing but the price for those has to genuinely hurt, ya know?

I think the axle shafts tend to hit the brass bushing more often as the knuckle bearings wear and reduce the clearance. If I am visualizing things correctly, the knuckle would move slightly upward as the bottom knuckle bearing "sinks into" the race a bit. Of course, this would also provide a new clunk potential with loose knuckle bearings....

DougM

DougM

I don't remember it was a while ago. Putting in the bushing along with an 800.00 birf just seems like the right thing to do along with the drive flange. The one I saw that was bad was easily recognizable as in one spot the grooves were almost gone.
 
FF Dana 60 out of a J**p J20... It's even offset. ;)

So the only question is when.

Of course, all of this begs the question of how much money you are going to spend on a rig that is too big for where you are headed.

Replacing axles on an 80 = coming to a classifieds section near you for a rock bottom price within 18-24 months. :popcorn:
 
You aren't going to finish the 40 because you are spending all of your time and coin blowing up your 80. Sell the 40, D60 the 80, go 40" plus, cut and tube, and then wheel the piss out of it. 40's are no fun, anybody can build up a 40. Try it with an 80 :flipoff2:
 
Is the roller bearing a replacement for the bushing or do you need to get an entire new spindle? I am close to rebuilding my front axle and think it would be a good idea to replace the bushings at least.
 
LOL! I'm building the 40 because I've always wanted on (and it kinda fell in my lap... Nothing like a free Land Cruiser!).

you mean no such thing as a free land cruiser right ? :D
(dont worry im still jealous)
 
Is the roller bearing a replacement for the bushing or do you need to get an entire new spindle? I am close to rebuilding my front axle and think it would be a good idea to replace the bushings at least.

Complete spindle only (at least in North America). It may be possible that replacement bearings and bushings are available for the new-style spindle in other markets. I think the new spindle may be from a 105?
 
Back
Top Bottom