Oil Flow

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I don't know the output capability of a stock pump, much less your modified one. As a general thing though I think I'd chose the filter able to handle the higher flow whether I needed that capacity or not.

What? The new find significantly cheaper?
 
From the F engine manual, oil pump delivery is >16 liters (>4gal) per minute at 1000 rpm of pump at 122-140 degrees F at 1 kg/cm2 (14.2 psi). I would presume the 2f is the same or better. I can't imagine you'd want to take a chance on the weenie filter.
 
Good find, Dave. I'm not sure if the 2F engine manual has the info, mine's out in the shop and I'm not. But the older 'F' manuals, both engine and chassis-body seem to be a lot more inclusive - the frame crack welding repairs as example.

It's as though Toyota expected owners to be making their own repairs and the repairs may be much more extensive.

I agree that it's unlikely that the 2F pump would flow less oil than an F pump does.
 
That's interesting. I've been using the Purolator PureONE PL30001 filter, I was just checking through the book to find a larger one. It looks to be about half again as large as the filter I'm using, that's why I asked.

But the PL30001 is only rated to 4GPM...Interesting.

Anyone know what the WIX filters are rated for?

I keep hearing about larger "2 quart" filters but can never find them. Anyone know the part # or application?
 
Back
Top Bottom