No More Stinkbug?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Looks good!

I know that the stinkbug stance isn't appreciated by all but its not a bad thing IMO. Heavy cargo or trailer tongue load levels out the 80. Good for not blinding oncoming traffic with your headlights (fully loaded) and good for climbing steep sections of the trail w/o the front unloading too much.
 
Those are all great points. I am specifically interested in the control arm drop bracket setup on this lift compared to the castor bushings.
 
Drop brackets are the better choice for zero bananas like me. They're bolt on and they do fix the caster, at least in the case of my 80. It's a much less intimidating job than the installation of Caster bushings, and easily reverseable in case you opt for a higher or lower lift at some future time. The drop brackets go with the lift.

The down side is that they do catch on things at times under some conditions off road so they have to be made truly robust. Mine cought on a 2 foot deep holes edge as I was climbing out of it. No big deal as it was only dirt, but I think the experience might have given a more indelible memory if rocks had been involved.


Kalawang
 
Looks good!

I know that the stinkbug stance isn't appreciated by all but its not a bad thing IMO. Heavy cargo or trailer tongue load levels out the 80. Good for not blinding oncoming traffic with your headlights (fully loaded) and good for climbing steep sections of the trail w/o the front unloading too much.
For those of us that don't approach the level weight EVER it screws us in night driving. My headlights are aimed up as far as they go and I still can't see anything.
 
Yeah, changing those castor bearings was a bit exciting, luckily had access to a high quality press, but this didn't stop my heart from jumping a few times when the old ones began popping out! Look over the change out instructions on slee's site and see what you think about the procedure yourself. The castor correction bearings are bomber once installed.
 
I'm a little worried about my rear susp. sagging if I opt for this setup, though I like its look very much. I'm planing on adding the JDM rear swing-out spare tire carrier later on and don't want to install the air-lift system to make it level again.

Does anybody know how much extra weight this setup can carry witout getting sagged?
 
Back
Top Bottom