Newbie's first tune up

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I swapped my birfs from side to side as soon as they started clicking... about 150K miles. Sold the truck with about 200K and they were doing just fine and I think they would have been fine for another 100K. Anybody can do it, its just messy. Well worth a days work.

Did you try to access you fuel filter from the drives side wheel well. Remove wheel and splash guard and its not so hard to get to. Might as well do the PHH at the same time.
 
Did you try to access you fuel filter from the drives side wheel well. Remove wheel and splash guard and its not so hard to get to. Might as well do the PHH at the same time.

3F-E.

5-0, Sounds like you're off to a good start. Have the valves adjusted as a next step. Spend some quality time under the hood cleaning out the plugged up hard vacuum lines, replace the old rubber ones, replace the EGR valve and modulator. You'll be amazed.
 
Hey John, Whats you take on swapping the birfs to the otherside? I dont wheel it much (because with the 33 I really need a lift. I would rather use the cash for a lift then to buy new birfs.)

New issue. I also adjusted the throttle cable, and I thinks its too tight. There is no more clunk when I left off the gas, but now the engine idles at 1200 rpm when in Park or Nuetral. Its idles at about 1000 when stopped at a light in Drive? Do I need to slacken up a bit?

Schlaker, I thought the fuel filter was on the passenger side. I tried from the top, from the bottom, every angle I could imagine. Bolts wouldnt budge on either end. I removed the plate and got the bracket loose, but could bet either line off. Does it take a special wrench?
 
Last edited:
Back
Top Bottom