New vs. Used oil level sensor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 20, 2018
Threads
4
Messages
15
Location
Apollo Beach, FL
I found that the Oil Level Sensor has a bad plug. I don’t know if anyone rebuilds these or they just need to be replaced. This brings me to my question do you buy a new one or used? They are $500 new but I found a used one for $40 on eBay. I am looking for recommendations?
 
If you're relying on the oil level sensor you've already lost, so I'd get the cheapest one you can find.
 
The plug on my sensor broke off as well and I was able to glue it back together with some two part plastic epoxy. So far it is still holding up. Been over a year.. Might want to try that first..
 
I think you're referring to the rubber gasket that seals the sensor to the block. So I found that cleaning the old gasket very, very well and reinstalling it with an intelligent application of FIPG worked perfectly.
 
It's not mission critical, your dip stick still works, right? The price is ridiculous from Toyota.
 
There is a replaceable rubber gasket which sits between the sensor and the block. Why use FIPG? The gasket is still available, and is like two bucks.
 
  • Like
Reactions: MoJ
The oil level sensor was made for soccer moms who never lifted the hood on their truck. Like Tools R Us said above, used the dip stick, it's the accurate way to keep track of your oil level.
 
Bench Testing a Used Sensor?
Is there a way to bench test a used sensor? I had a sensor fail a year ago; found a used unit at a Pick n Pull and it didn't work either. I can't detect any change in continuity when I manually move the float up or down. I refuse to spend $$$ on a new OEM unit but don't want to throw more money at a used sensor that may be bad.
This might be helpful for the OP as well...
 
IIRC, the sensor switch should be open when up, proper oil level, closed, provide ground to the light when down, low oil level. They tend to collect gunk, have had luck from cleaning them in the ultrasonic.
 
IIRC, the sensor switch should be open when up, proper oil level, closed, provide ground to the light when down, low oil level. They tend to collect gunk, have had luck from cleaning them in the ultrasonic.
Yes, that's what I see from the wiring diagram. Also confirmed in this thread:
Oil level sensor?
What I'm curious about is the float switch itself. How does it work? I removed the arm with the float and get continuity between the arm (ie:ground ) and the + wire all the time. It doesn't matter whether the float is up or down. The float should complete the connection only when it drops down. I don't see anything that would complete a connection even if it were working properly. The float just appears to be bakelite. It's got a metal center shaft, but that metal is insulated from the shaft it rides on.
Does the float need to be soaked in oil to be tested properly?
 
how does 1 check the oil level guage like if u buy a new one , how do u check if it works or not .
on a 1hz engine can any one show a pic to where its located .
 
Look guys, I am new to these trucks and am trying to learn. I love the truck and would like everything to work if possible. I am aware of the dipstick under the hood, thanks for that advice. I went with @ariff plan and was able to fix it myself. Thanks for the help.
 
Back
Top Bottom