New member

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 8, 2019
Threads
2
Messages
3
Location
Calgary Alberta
Hello all. I'm Murray and reside in Calgary Alberta. I'm the new owner of a well used 1977 FJ40, with a carb'd 350 conversion (aka "Rusty"). Currently riding on 33" Micky Thomson M/T's with a 4 inch lift. Some years ago my daily driver was a much loved 1982 BJ60, but it was sold (sadly) as it was frankly bleeding me dry.

The "new" truck was purchased from out of province, and thus needs to pass an out of province inspection before I can get it on the road. Short term plan is to have it's many issues repaired so I can have it on the road for June. That includes making it more street-able by updating suspension and tires. Medium term I hope to get to the body. There's a wee bit of rust in the rear quarters, rear sill, front fenders, windshield frame...... etc. etc.

I've never been much good with a wrench, but I'm hoping to overcome my lack of mechanical skill with a little more time and effort. And of course with the sage advice of those of you here!

Looking forward to learning all I can.

1973072
1973073
Red7740x4.jpg
 
Back
Top Bottom