New LC Owner!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 19, 2016
Threads
23
Messages
278
Location
Colorado
I had posted a while back that I was searching for an LC looking for some input. Well right before Christmas I flew down to San Antonio and picked up a 1993 with 173k. No lockers, but the interior was very clean (and NOT leather!) so I pulled the trigger. An uneventful 14 hour road trip later and Lucy the Land Cruiser was home!

Tons planned for her, but not until my house remodel is done. Just preventative and maybe a 2in lift so it doesn't look so funky with the larger tires. Planning on a front end rebuild, which worked out perfect since Poly Performance had a 12% off on RCV axles a few weeks ago. Just need to source a seal and bearing kit, oh and for it not to be 4 degrees outside... PO has mangled most of the plastic parts which sucks, but the ones that are truly broken it seems are readily available, so those will be replaced too.

Anyway, what is an intro thread without some pictures?

IMG_1151.jpg


IMG_1158.jpg


IMG_1176.jpg
 
Nice looking rig and pooch.

There are lots of vendors on here that can help with an axle rebuild kit. I've personally had great experiences sourcing needed parts with Kurt at Cruiser Outfitters. You're also in the right state if you want to shop at Slee and save on shipping for all the goodies they have to offer.

Congrats on the new ride!
 
Nice looking rig and pooch.

There are lots of vendors on here that can help with an axle rebuild kit. I've personally had great experiences sourcing needed parts with Kurt at Cruiser Outfitters. You're also in the right state if you want to shop at Slee and save on shipping for all the goodies they have to offer.

Congrats on the new ride!

Thanks! Have two puppies that are 1 and not quite 1, no idea what my fiance and I did before we had them... They totally rule our lives!

Yep, I dropped into Slee shortly after I picked her up. Have driven by their location for the last 15 years, but never stopped in. Leaning towards their step sliders as getting in and out of her currently is a little more difficult than I'd like. Like the look of the Man-A-Fre ones, but they also look super heavy and would prefer to not weld the mounting tabs on. But it seems that produced parts are limited and do not have the time to make my own currently...
 
Good lookin' rig.

What makes you think that your axles need to be replaced? At 173k I would think that the front axle just needs new seals, gaskets, grease, and possibly bearings.
 
Nice find & welcome

RCV axle's are not recommended for full time 4 wheel drive, I am running them but not a DD trail reg only
 
Last edited:
Good lookin' rig.

What makes you think that your axles need to be replaced? At 173k I would think that the front axle just needs new seals, gaskets, grease, and possibly bearings.

Popping noise from the front end when turning, nothing more. I usually assume the worst, especially when it comes to used vehicles. It does sound like the tires rubbing, but I have not been able to locate where if that is it...
 
Looks like beige 4K1? If so, great choice!

Congrats and good luck!

Yes, it is beige so I am assuming 4K1 is the color code? This is my first Toyota, coming from 100% Jeep and Ford before.

Nice find & welcome

RCV axle's are not recommended for full time 4 wheel drive, I am running them but not a DD trail reg only

I read this as well. It will not see many miles. I sold my '12 Raptor because it just sat. And saw a Land Cruiser in Seattle last year that set me on the path to owning one!
 
Back
Top Bottom