New LC Owner (1 Viewer)

[bloomjLC]

Hello everyone,

Well it took a while but we finally decided on an LC. Got a good deal on a new one. Gray/black. We had the windows tinted and then I ceramic coated the truck to keep her nice and shiny.

 

[Sandroad]

Good decision! Shiny now, but a bit of dust at least around the edges really helps the looks of a cruiser

I see an EV charging cord in the garage. What’s the other vehicle?

 

[04UZJ100]

Salesman are typically not familiar with Cruisers.

FYI it is not electric or plug in.

 

[bloomjLC]

Good decision! Shiny now, but a bit of dust at least around the edges really helps the looks of a cruiser

I see an EV charging cord in the garage. What’s the other vehicle?

Good eye! I offset my carbon footprint of my gas guzzlers with a Model 3.
This beast is my wife’s new baby. Sadly it won’t see much more than pavement, at least until she’s done with it.

 

[WHB III]

What tint percentage did you go with? I too have a 21’ Grey/Black and want to get it tinted but not sure if I want to do 35% or 20%. Do you have a side photo?

 

[kbohtx]

The best color combo, congrats!

@WHB III I have MG with 35% tint. Here's some pics from the side:

Bilstein 6112/5160 Installed

I also went with 2721 springs. See my quoted post below. I have about 0.75" of rake on setting #5. Depending on how much rake front to back you have currently, may need more lift on the front to get it leveled. Thank you for the info. Looks like u have a front bumper so that brings the...

forum.ih8mud.com

 

[04UZJ100]

What tint percentage did you go with? I too have a 21’ Grey/Black and want to get it tinted but not sure if I want to do 35% or 20%. Do you have a side photo?

20% front 5% rear Rayno S9 ceramic 92% heat rejection.

 

[bloomjLC]

What tint percentage did you go with? I too have a 21’ Grey/Black and want to get it tinted but not sure if I want to do 35% or 20%. Do you have a side photo?

Mine is 35% on fronts and tears all 80% using Xpel XR. It was done to attempt to make the fronts match the rear factory “privacy” glass color. I don’t have any good side shots but I’ll attach what I have anyway.

The best color combo, congrats!

@WHB III I have MG with 35% tint. Here's some pics from the side:

Bilstein 6112/5160 Installed

I also went with 2721 springs. See my quoted post below. I have about 0.75" of rake on setting #5. Depending on how much rake front to back you have currently, may need more lift on the front to get it leveled. Thank you for the info. Looks like u have a front bumper so that brings the...

forum.ih8mud.com

How are you liking the 6112/5160 setup? I would like to level it with the Toyota spacers but have reservations using spacers. On my truck I installed 5100’s all the way around and it worked out well. Go aggies!

 

[WHB III]

Thanks for the photos! I’m thinking 35% is right for my use!

 

[bloomjLC]

You’re welcome. We wanted it tinted primarily for heat rejection and secondary for looks to make the front and the back windows look the same.

Thanks for the photos! I’m thinking 35% is right for my use!

 

[bloomjLC]

Finally got it out in the daylight.