NEw Dash

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 26, 2004
Threads
14
Messages
50
I was looking to do a complete rework of my dash, right now, the original dash is completely cut up and mostly cut out (due to PO) I was wondering where I could find 1. an unmolested dashboard that I could weld in, or 2. A plate of sheet metal that I could cut holes in. Does anyone have sources around the Houston area?
 
I just PM'd you.

Ed
 
Weird! You can also email me through MUD. I just want to give you an address that I don't want to publish.

Ed
 
I have a brand new NOS dashboard from the dealer. It is for a 78 or newer model 40 with the side defrosters.
 
Or if you really want to go cheap and be creative, you can buy some 1/8" aluminum and get a jigsaw and make your own cover plates. My '75/40 dash was all cut up. I covered it all up with aluminum plates and attached them with 2 way tape. Then I ran a bead of acrylic latex caulking around the perimeter and painted it.
custom dash.webp
 
Land Cruiser Junkie,
Something tells me that I'd like to see the rest of that cruiser of yours... got more pics?
 
honk said:
Land Cruiser Junkie,
Something tells me that I'd like to see the rest of that cruiser of yours... got more pics?
I 2nd that.
 
The advantage to the aluminum plates is instead of looking like you've made cover plates, you can give it a "stamped" look. Here's another pic of the dash. I made plates to cover up where the rubber padding used to be, then I mounted all of the pulls on the bottom. Never did like the layout of a stock '75 dash.

TXcruiser68, I don't mean to highjack your thread, but here's a few more pics for the guys. As you can see, I've modified a couple other things too.
dash.webp
 
Land Cruiser Junky
Nice Job! !



Nocents
 
That thing is amazing!!!
 
Lashcat said:
LCJ where did you get the air cleaner?

I bought an open air filter from Pep Boys, and had the sheet metal workers on my jobsite make the Ram Air set up. Bought the ducts at Home Depot. Whole thing cost about $50.

Okay, now back to customizing your DASH.
 
LCJ, no problem, you have actually given me some ideas,

Dash box would be cool, but it still doesn't help me with all the holes/ partially cut out dash.

LCJ, since you're the aluminium guy, do you think that I could just get a sheet of it, give a fab shop the measurements, where the bolt holes should be at, and cut new holes where the switches should be at and then have a metal shop fab up a piece? How thick do you think it would need to be in order to be stable? Any words of advice for fabbin' out of Alum?
 
That really is cool and i hope to steal part of that dash layout. Very nicely done.

Do the holes in the apron work to the side like that? I remember when one of the motorcycle companies introduced a ram air system they found it ran lean in a crosswind because the air blowing perpendicular to the opening caused a suction rather than a high pressure area. Much like if you blow across the top of a straw the liquid rises in the straw rather than blowing bubbles in your chocolate milk.
 
Back
Top Bottom