Ok, where to start. My wife’s rig (97 with 200k) has developed a loss of power and sometimes holds a gear too long and shifts hard. I think her cats are clogged (I’ll explain why below) but would that cause hard shifting? It’s got a current CEL for the downstream O2 sensor that I would have already replaced if the stupid PO hadn’t welded it in place!!
I recently replaced the brushes in the alternator and noticed a pronounced rattle in her first cat. The first day I gave it back to her she called me and said it had lost a lot of power and she could smell something burning. Upon opening the hood I found that the VSV had melted. I figured that the back pressure had caused this but I honestly don’t know. I did the resistor mod and plugged all the vacuum lines and it still has no power. In addition there just doesn’t seem to be too much pressure coming out of the tail pipe whether at idle or throttle.
Like I said I think it’s a clogged cat but the hard shifting is throwing me off. What sayeth the experts?
Thanks for any help.
I recently replaced the brushes in the alternator and noticed a pronounced rattle in her first cat. The first day I gave it back to her she called me and said it had lost a lot of power and she could smell something burning. Upon opening the hood I found that the VSV had melted. I figured that the back pressure had caused this but I honestly don’t know. I did the resistor mod and plugged all the vacuum lines and it still has no power. In addition there just doesn’t seem to be too much pressure coming out of the tail pipe whether at idle or throttle.
Like I said I think it’s a clogged cat but the hard shifting is throwing me off. What sayeth the experts?
Thanks for any help.