More Cup Holders?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I'm definitely in for my '73 console once available. Amazing work.
 
im in for a 78 and i dont even have a center console yet! gotta get on that i guess.
 
So I need a volunteer who has this console to install my cup holder for final fitment verification and pics. The console I used is in 5 pieces and held together with duct tape. It's a super close fit but I'm not 100% sure it's a perfect fit since the console has some flex to it. The console I need to test fit on is pictured below with a pic of the cup holder. If someone is willing to pay to ship it I will send them the prototype for free. Shipping should be around $10. Let me know if there are any takers. IF it's not a good fit (it should be) then I will send another updated one until we get it perfect.
117c.gif
$_1.jpg
20170731_104955_resized.jpg
20170731_105001_resized.jpg
20170731_105016_resized.jpg
 
I've got one you can use for how ever long you need it. Pm me address and I can send it over.
Your willing to ship me the larger later model console? You sure you don't just want me to ship you the prototype for test fitting? It's just a basic square hole so fitment should be super basic.
 
Ill be your guinea pig!!!
Thanks for the offer. I see your in Canada. Shipping prototypes back and forth may get rather costly for me. I will use 77landsitter (assuming he's in the US).
 
The early metal stamped console was shipped out to me today. thanks @iptman for doing that. I should have it within the next few days and will get that project going. The middle years console single and double cup holder design are pretty much done and the later years console design should get shipped out for test fitting tomorrow. I'm still shooting to have this product available in early September.
 
Are you taking advance orders? Don't want to get stuck at the back of the line. Congratulations, I think you going to be very busy once the cat gets out of the bag!
 
Are you taking advance orders? Don't want to get stuck at the back of the line. Congratulations, I think you going to be very busy once the cat gets out of the bag!
No pre-orders but I will make a good size batch of every Style.
 
$_1.jpg

So @77landsitter has this console but unfortunately I just found out it is not in his 40. Does anybody in the US have this console installed in their 40 and willing to allow me to send a prototype to you for fitment and pictures?
 
Last edited:
So the earlier stamped metal console showed up yesterday in the mail. I will get to work on that design today. The later (rear heat console shown above) prototype shipped out yesterday for test fitting and install pics. Hopefully I will have all of the cup holder designs done within the next week and start production on them at that point.
 
Last edited:
Awesome!! My console arrives tmmrw! cant wait for the cupholder!
 
The wife is sooooooooo excited about a cup holder for Miss Scarlet!
 
So I got the early center console in my hands now and I have a couple questions. I am attaching a pic of the console below. Here are my questions: What part of this console is level/parallel to the horizon line? Is the top level or the bottom of the console because the top and bottom are definitely not parallel with each other. Also, is the bend in the back area of the console supposed to be there or did this console get damaged and the back 1/2 of it got bent upwards?
2.jpg
 

Users who are viewing this thread

Back
Top Bottom