More cruiser lean

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 12, 2005
Threads
7
Messages
68
I am about to install an HFS 4" lift on my 77 FJ-40. It has the standard rear sag and lean. I have heard that new springs wont correct the lean, But companies sell a block that you install with your spring pack to correct it. What exactly is out of whack that requires a shim? Body or suspension?
Thanks to all :beer:
 
I installed cool cruisers shim and it took all the lean out of my cruiser. However, I noticed that on the stock u-bolts the extra width does not allow the nuts to tighten all the way down. Does anyone think I should buy extended length u-bolts?
 
fussy_cruiser said:
I installed cool cruisers shim and it took all the lean out of my cruiser. However, I noticed that on the stock u-bolts the extra width does not allow the nuts to tighten all the way down. Does anyone think I should buy extended length u-bolts?

As a rule of thumb you should see at least 3 threads on the end of the bolt sticking out of the nut. U-bolts should not be re-used as the bolt will be over stretched and will likely break.
 
Here's how I got rid of my Cruiser-lean: Go rallye the piss out of your Cruiser on some bumpy, jumpy desert roads until you break off your front and rear shock mounts on one side of your Cruiser. Keep rallyeing the piss out of it until the side without shocks (front and rear) sags very badly. Then just swap springs from one side to the other on either the front or the rear. Worked perfectly for me! :D :doh: :flipoff2: :cool: Also helps to have your Cruiser full of heavy ass dudes and other crap...

-Ferg-
 
Back
Top Bottom