missing a gear

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2014
Threads
5
Messages
31
hey guys hope everyone is doin great. so my 92 seems to be bypassing a 4th gear. I can drive in 3rd then shift into d and feel a 4th gear for just a second or two then it goes into overdrive. she would handle the freeway a lot better if it could stay in that gear or shift down to it instead of shifting down to third.
 
My wild guess is OD lockout button is pressed in. Shifts into 4th, and then almost immediately locks the torque converter.
 
I don't think I have that button but i'll look tomorrow. she's a 92 with the 3fe. that would make me feel like an idiot if it was the problem. I've been noticing this for a couple years now.
 
It's on the other side, but you get the idea.

sdc10957-jpg.442249
 
On my A442F, OD IS 4th gear, which is separate from torque convertor lockup. With the shifter in D, OD button on the shifter handle depressed, it functions as a 4 speed. With the OD button popped out, it functions as a 3 speed. Torque convertor locks up in 3rd and 4th on this model.

Maybe your kickdown cable needs adjusting?
 
92 = a440f 4 speed fully hydraulic. I don't know a ton about them but adjustment of kick down so it holds gears longer? Just a guess. I'm all electronic
 
yeah no O/D button. was curious if anyone has wired a separate lockup switch. could try and adjust kickdown some I guess but kickdown seems to work good throughout the rest of the cycle.
 
3Fe gear shift recommendations for pavement driving:
Flat road D unless you a bucking a head wind then 3.
Down hill D.
All others scenarios 3, then 2, then 1, then unlock the CDL (7 pin mod) then Low 3

Sounds like nothing is wrong with your transmission.
 
3Fe gear shift recommendations for pavement driving:
Flat road D unless you a bucking a head wind then 3.
Down hill D.
All others scenarios 3, then 2, then 1, then unlock the CDL (7 pin mod) then Low 3

Sounds like nothing is wrong with your transmission.
I know she's gutless. especially after lift,tires and gear. I did do 4.88's which helps a lot but planning a v8 swap soon.
 
Does anyone know if it's possible to wire a switch to control the converter?

As @cjmoon stated the 92 transmission is fully hydraulic. The torque convertor is not controlled electronically but hydraulically. Not to say it couldn't be done, especially on this forum, but highly unlikely to electronically control the torque convertor used on the 91, 92's.
 
i think the only lockup type converters are electronic i don't know the 440 series very well does it even have lock up? if it does then there are a lot of wire diagrams out there with pulling brake light sensors and several relays and what not but really find the wire and have a 12v switch and your in the money. it will pull it down and kill the engine or loose pressure and slip be careful
 
Back
Top Bottom