Marston Mats

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2006
Threads
54
Messages
536
Location
Philadelphia, PA, USA
Looked around this forum and couldn't find anything.

I'm looking for some Marston mats on the East Coast, Philadelphia Area. I can only find them on the West coast for sale. Does anyone know of a source? The west coast company will ship them here, but it's $300. I guess if there is enough interest from others, we can combine shipping.
This is what I was quoted. They quoted 10' mats, I wanted the 5' ones, but the cost will be roughly the same.
12-10' Mats- $420
Shipping- $295.68
Total Cost= $715.68
 
I guess my question for the op should have been , what are your planed use for them?

The ones I linked from a google search was nearly half the cost. Although not sure what shipping would be
 
I know the company you are looking at as I was turned onto them awhile back.

We used to use them in logging landings as a kid for all the swampy spots you needed to get to with either passenger vehicles or log trucks. We always left a good chunk of rope & survey ribbon on the free end to mark where we ultimately had some with 2-3"+ of mud & rock over them.

(I used to tie the rope to the back of the skidder & yard them up that way. ---Sorry Mark, that was why all the mats I retrieved were bent as heck when you saw them & made me run them over a bunch to flatten them. I wasn't even 18, so mea culpa Buddy)
 
I found a bunch of Marston mat (AKA PSP, perforated steel plank) out in the desert near 29 palms where it looked like they were used to get something unstuck. I took 5 of the straightest pieces home and chopped them into half for pieces that weigh about 30 pounds each. I sold about half of them and sill use 3 half pieces for my welding table. Although they are nostalgic, they really are too heavy to carry around as sand ladders even if you get them for free.
 
Last edited:
I want two for the truck, they will double for a ramp for my forklift. I also have an area that gets muddy after really big rains, I don't own the property, so I don't want to go through the expense of paving it. These would be good for the area.

The plastic ones someone mentioned flex to much and would not bridge/ramp for my forklift
 
Back
Top Bottom