Lowering my lift

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 10, 2018
Threads
8
Messages
28
Location
Virginia
Hi all, I could use some suspension assistance.

I have a 75 FJ40 which another owner had lifted. Not sure how much but the owner I got if from thought maybe 4 inches. It actually rides nice but I want to lower it so it has around 2 inches of lift. I've attached a few photos of what it looks like. I want to keep it level, so not sure if I can just get shorter shackles front and back. The front attachment point was moved forward and the springs/shocks are aftermarket. Any advice would be appreciated.

- Jim

20190706_115127.webp


20190706_115138.webp


20190706_115151.webp


20190706_115156.webp
 
The rear springs are flipped to give it a tad longer wheel base... or it was a mistake :meh:

They used 2.5” skyjacker springs on front with a SR and 4” rear (flipped) skyjacker springs with a really long shackle that brings it to over 5” in the rear

I assume skyjacker as that’s what they look it to me


IMO Flip the rear back to correct... and use shorter shackle ... that will even out to the front ... then get 33” tires

Those (31s I think) look tiny because 31’s are tiny
 
Depending on how you plan to use it, you may want to completely redesign the front suspension. The current design is known to create rock finders.

If you’re not worried about rock crawling prowess, I’d redesign the front shackles to have the upper mount through the frame rail. The shackles could be the same length... or perhaps even a bit longer. The end result would be “shorter”... but you would also need alignment wedges to correct alignment changes.
 
Last edited:
Btw another reason I went with skyjacker was you said it had a good ride... skyjacker soft ride springs are what you have imo
The rear springs are flipped to give it a tad longer wheel base... or it was a mistake :meh:

They used 2.5” skyjacker springs on front with a SR and 4” rear (flipped) skyjacker springs with a really long shackle that brings it to over 5” in the rear

I assume skyjacker as that’s what they look it to me

Actually the are Rancho 9000s. The bushings need to be replace but otherwise they seem fine.

The rear springs have a marking on them - 444414. Not sure who the manufacturer of that is.

As for flipping the rear springs and a shorter shackle - that sounds doable enough but won't that leave it looking lower in the rear than in the front? The top picture I took has it sitting on a hill so it may look as if the front is lower but on flat ground if is pretty even.
 
Back
Top Bottom