It's Another Overheating Thread!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

dont dspair, head removal and machining on mine was about $1500 (in CA), but the bottom end was flawless. Mechanics said it looked like a brand new engine (@165k). I too was down and out for a bit, but never question my decision and am stoked I didnt bale out on her.

Dont forget to adjust the valves after a gas tank or two after you get it done;)
 
dont dspair, head removal and

Dont forget to adjust the valves after a gas tank or two after you get it done;)
No need to set your valves twice on a 1fzfe, have machine shop set them when head is off , check that they are in spec at the bigger end since they get tighter with wear
 
Back
Top Bottom