Is my dizzy seated?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 24, 2019
Threads
8
Messages
21
Location
Idaho
Is it normal to have 1/8 inch space left? This is as far as it will go. Same size as the one it’s replacing. I turned the motor over as it was being seated and it felt like it dropped into place. Appreciate all the advice.

347D1CC5-5622-41CB-B970-3129DE16D75B.webp
 
X2 what @whitey45 said!

Its either not fully seated in the oil pump slot, or you need a spacer.
I would pull it and verify (again) that the shaft and gear match what you’re replacing.

It they match and the old dissy didn’t have a spacer, it’s not seated correctly.

Be very careful you have oil pressure.
 
75 2F engine. Pertronix electric dissy. The O-ring is about 1/16 below the edge you can see. When I put the old one back in it sits at the same place.
 
If it is a 1975 dissy, then it is probably fully seated. They register the drive gear on top of the oil pump, and the dissy sits a little above the block.
 
Back
Top Bottom