Inner Axle Seal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Yup. Seal puller, or you can take a piece of stiff wire (coat hanger), bend a short hook at the very end, then slowly tug it out.

My preferred tool for getting these out:

91352.gif
 
You could probably get a slide hammer/puller in there.
 
Tonya beat me to it!
That link does not answer the question.
What captain kangaroo axed wuz can the inner seal be pulled without removing the k-nuckle.
Do those new beefy Marlin inner seals work on 80 series? At least the old FJ80's? His site says up to 1/90... Mine was built in 3/90.... I'm assuming he means thorugh FJ62 though.
 
Tonya beat me to it!
That link does not answer the question.
What captain kangaroo axed wuz can the inner seal be pulled without removing the k-nuckle.
Do those new beefy Marlin inner seals work on 80 series? At least the old FJ80's? His site says up to 1/90... Mine was built in 3/90.... I'm assuming he means thorugh FJ62 though.

There were some at the bottom of the page that had the fj80's. Speeda thay about two more pictures down.
 
Yeah but I want those ballin' super-duper-seals!
I'm thinking with those bias 37" Iroks, those axles aren't getting slapped, but they sho gettin' shaked the sh!t out of.
 
Yes, marlin has new seals for the later 80 series :D

Mines not a later series, it's the earlier series as in Mighty 3FE... but I bet they will work! I'm bout to call!
 
When we tore my truck down for the head gasket and supercharger install I found out that I had a slow leak of diff fluid out of the PS that was dripping on my tire. I/we had rebuilt the front axle about 2 years ago with Longfield's birfs & axles.

On the PS, the inner axle seal was hashed bad. I'm not sure if it was an installation error from when I did it to years ago or what. PS was birf soup. The seal came out without removing the knuckle. I used a flat crafstman 16" (or so) pry bar to pull it out.

I wanted to make sure that the birf soup hadn't gotten into the DS. So, we tore down both sides. Inspection and repack, found one wheel bearing with slight wear on the driver side and replaced that. Drivers side was all nice grease still. Since it was open, I repacked it all anyway.

I put the Marlin inner seals (sourced from Sleeoffroad) into it. They fit nice and no leaks yet, but its only been 3 weeks so we'll see. They really are a -lot- thicker than the OEM ones.

IMHO YMMV
 
Hasn't anyone ever heard of a real seal puller. Like the reversible jaw slide hammer ones from snap-on or matco?

21140.JPG


I know they are more expensive than a screwdriver, but they also don't have the possibility of marring your seal races like a screwdriver does. I'm pretty sure you can rent them from autoparts stores.
 
However you do it, I found that the seals came out much easier if I first distorted the seal on one edge with a light hit. That might be especially helpful if you're trying to remove it from an awkward angle.
 
Back
Top Bottom