Important Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

has any one mounted there own tires to rims. if so how? was it hard? Do you need a really big tire iron?

It's a pain in the ass for sure...you need more than just a big tire iron...you also need a LOT of muscle and some jumping up and down on the tire too...there are a few ways to do it, including using ether (but that's something you shouldn't really play with too much as it can turn out disastrous).

Search on google for mounting your own tires...you may get more ideas and realize it's just worth it to take it to a shop and pay the minimal fee to have them mounted and balanced professionally.
 
When I was young I tried to mount an ATV tire.

What a lesson!! After two days of struggle and trying this and trying that, I paid the shop the $ and learned a good lesson.

IMO, If your short of cash, donate some blood/plasma and pay a shop to do it.
 
Bear in mind that if you make something wron or if any of your tools slips a bit you can end up with a bent or chipped rim. IMO changing tires manually on alloy rims is risky. If you have steelies then have fun. If anything bends you can always bang it back with a hammer.

BTW what are the costs of changing a tire and balancing it in the US? Just curious. I pay $7 per tire over here and find it reasonable.
 
I did play with that for a bit. Bought a tire mounter (manual) device from HF. Worked just fine for smallish as in trailer tires. After a bit of practice took all of 5 mins to mount one. (of course took a couple of hours to mount it on concrete)
When I did graduate to 15" tires I bent the handle trying to get the tire on but got put on finally.
Was all of $40. Obviously poor steel.
Note these were steel rims. Possible an alloy may have been damaged more readily.
Don't know what a good steel version would run for the mounter. Maybe $100 or $150. But that would be at least 10 tires worth. So, it's possible but may not be worth the cost?
 
I don't know how much mounting and balancing costs near you but for me it is $25 per tire and I don't have $100 that I can spend on that.
 
http://www.nomartirechanger.com/06ProModel.html But only if the tire is smaller than 40".

I have the jr.Pro and have used it for multiple car and motorcycle tires without a hitch. It's actually much quicker once setup than most pneumatic machines... Kind of pricey unless you go through a lot of tires, but you don't have to pack up and head to the store nor wait in a line. Then once you mount the tires you then need to balance them somehow...
 
I don't know how much mounting and balancing costs near you but for me it is $25 per tire and I don't have $100 that I can spend on that.

Keep calling around. $100 would be really expensive even in my neck of the woods. When I lived in Salt lake most places did it for $12 per wheel.
 
Back
Top Bottom