Ignition and timing woes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 16, 2016
Threads
38
Messages
334
Location
Auburn Al
I’m having ignition and timing issues.... I pulled the distributor and set to tdc using the B.B. on the flywheel but still nothing. Pulled it out turned it again thinking I was maybe 360 out but still nada. I was reading the procedure in the manual and it was saying the rockers on #6 should both be closed but I have yet to line the B.B. up and have both closed. Is there something I'm doing wrong? I have also confirmed I am getting spark to the plugs So I'm fairly certain that is not the problem.

20903FE5-59E0-4D4A-B971-42046B5ADE0A.webp


B526EC93-48AB-406B-8723-FA5268C3094B.webp
 
#1 not #6. #1 should be on compression stroke with both valves closed.

Dissy.webp
 
After repeatedly trying with timing marks I just pulled the spark plug out of cylinder number one and found Tdc that way and realized it was nowhere close to the marks on the flywheel. Would a 2f flywheel have different timing marks than a 1.5f?
 
I just pulled the spark plug out of cylinder number one and found Tdc that way and realized it was nowhere close to the marks on the flywhee

Just to confirm, did you put did you bring it to TDC by the line on the flywheel, and then check the # 1 piston position?
 
...and both valve rockers for #1 should wiggle (i.e. no spring compression so both valves are closed as needed during compression).

@Steamer whats the source document for your figure? I need that.
 
...and both valve rockers for #1 should wiggle (i.e. no spring compression so both valves are closed as needed during compression).

@Steamer whats the source document for your figure? I need that.

I just don't know. I've had it in my files for quite some time. I'm sure I got it here from a post by some one else.
 
Last edited:
Update! Got it to fire and idle for about 20 seconds. I think I just kept putting it in a tooth off. Anyways thanks for the help everyone!
 
Back
Top Bottom