Started with a flatbed M116 trailer. Frame for tub and tent is done. List of equipment includes: Rooftop tent, two tool boxes, propane water heater, shower, 20 gallon water tank, rollout table, slide out cooler, deep cycle battery with inverter.
IDAHO EXPEDITION TRAILER BUILD (1 Viewer)
- Thread starter ladnav84
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
- Thread starter
- #3
- Thread starter
- #4
- Thread starter
- #5
- Thread starter
- #6
Coming along...getting walls on...and working on slide out table.
- Thread starter
- #7
Hella stout
What's in the sidewalls? I thought water tanks maybe, but saw there was plywood peeking through?
What's in the sidewalls? I thought water tanks maybe, but saw there was plywood peeking through?
- Thread starter
- #9
Just plywood to support the skins. The water tank will be mounted in the front. The bulk of the back will be open space above a slide-out table made from an old office door.
- Thread starter
- #10
Slide-out for cooler.
Be sure to seal the edges of that particle board core....man, does that s*** love water!
- Thread starter
- #12
Thanks titanpat57
- Thread starter
- #13
- Thread starter
- #14
- Thread starter
- #15
Billyfj7312ht
Should only take ten minutes
You've done so well on the trailer, don't use the particle board table, it will last 2 wipe ups from spills unless you skin the whole thing.
just sayin!
just sayin!
LFD2037
TEXAS LEXUS!
What size tuning and 'shocks' did you use? Happy with them? It should go as high as you want it but that depends if you'll have an annex under the tent or not.
- Thread starter
- #18
50# & 14" throw. Just going up about 13"
- Thread starter
- #19
That gives us about 6' 1" from the ground to the tent base. Yes, there is an annex.
- Thread starter
- #20
Already skinned...it's an old office door.
