I need suggestions on WHAT to line on my 60

[NLXTACY]

Update: Need to work on getting the truck smogged and lifted this weekend BUT....

I have been SERIOUSLY considering using SecondSkin's DeadLiner roll-on/spray on bed liner to put OVER the Damplifier Pro I will eventually be getting. This is instead of the Rhino Lining. Any thoughts?

This is JUST for the interior. Exterior would still be Rhino.

 

[bergerob]

Layer right?

Is this the right layer by layer process ?

Sheet Metal floor - Second Skin Damplifier - Roll-on/Spray On Liner (Over the damplifier) - Noise Barrier (Luxury Mat) - Carpet

 

[NLXTACY]

Is this the right layer by layer process ?

Sheet Metal floor - Second Skin Damplifier - Roll-on/Spray On Liner (Over the damplifier) - Noise Barrier (Luxury Mat) - Carpet

If I wanted to go the whole process, yes after talking to SecondSkin. But I won't be putting carpet back in myself so it will be:

• Metal floor
• Removed tar layer (with dry ice)
• Second Skin Damplifier Pro
• Second Skin DeadLiner (roll on bed liner)

Again, I'm not 100% sold on it but I am very much so considering it.

 

[TX650L]

So can the Second Skin Damplifier Pro be covered by a regular spray in? How thick is that stuff? I'm looking at doing the same thing. I figure if it's too loud in the cab i'm just going to put carbet back in the front and back seat area but leave the rear bare. Also I am getting the rear of my back seat covered. The little piece of trim that hold the top of the seat cover down is at the powder coaters right now.