I have this (pictured) small connector I need wires soldered to. I have tried but so far have failed and Im done trying and looking for help. I 4 terminals on a male and 4 terminals on the female connector I need help with.
I need soldering help
- Thread starter LandCruiserPhil
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #3
Because I cant do it anytime is good
This is part of my ~$15 winch remote control set up.
If you dont have remote control on your winch this mod might be of interest to you
This is part of my ~$15 winch remote control set up.
If you dont have remote control on your winch this mod might be of interest to you
Are those gold plated?
- Thread starter
- #6
- Thread starter
- #7
Yes Chinese gold similar but not to be confused with Mexican gold
Wouldn't that require a special flux/solder? Chinese flux in this case.
I wouldn't bother with solder. I bet with a bit of work you can find a female connector that'll work. Those pins look about the size of the ones coming out of ECU's. Pep Boys, etc. sells packs of a variety of connectors that size.
Jim
Jim
Probably been there, but would std 4 pin trailer connectors work as a sub?
Last edited:
I saw Phil yesterday, he was updating some solar components and was getting ready to clean up a few other loose ends. He never commits to being anywhere but always seems to show up everywhere, the next great adventure might delay his getting this mod finished anytime soon.