I checked part numbers and orientation. I don't have the axle tightened down yet but I have to pry the shackle down for anti-inversion pin in?

[arlenroy]

 

[JackA]

If there's no weight on the springs.....chances are yes. Or just add that pin once on the ground.

 

[arlenroy]

If there's no weight on the springs.....chances are yes. Or just add that pin once on the ground.

Great thank you, I was thinking that but the few videos I've seen they had it in or weren't too specific on that part. It was mostly proper tightening. Thanks again!

 

[jim land]

Ironman spring are know to be too short and have some bad reviews , and i never saw a good one on mud

 

[arlenroy]

Ironman spring are know to be too short and have some bad reviews , and i never saw a good one on mud

Man, I read through quite a few reviews, more positive than negative, but Old Man Emu was on backorder for months. I don't plan on going out in this one, at least not for a while. But thank you for the heads up on the length. I'll measure my old ones and try to find dimensions for stock length.

 

[jim land]

Hope you find a way to get a good shackle angle, some relocate the hanger for this

 

[arlenroy]

Hope you find a way to get a good shackle angle, some relocate the hanger for this

Thank you, not sure how to relocate the hanger if they're welded on. I mean I could cut it back and reweld it but I'd rather try to make it work.